[meteor_slideshow slideshow=”arp1″]
1.The average length is approximately 60 PAGES including illustrations and with no more than 30 pages of appendices (total maximum number of pages between 90-110).
2.Form of the Project must be:
Table of contents
Symbols and abbreviations
Introduction
Previous work (Literature Review)
Theory, methodologies developed/used
Work done and results obtained
Discussion of results
Conclusions (including a clear statement of what has been achieved)
Suggestions for further work
References
Acknowledgements
Appendices
3.The margins for the title page (paper size A4, left margin 4 cm, right margin 2.5 cm, top margin 3 cm and bottom margin 2.5 cm; header 0 cm footer 1.5 cm) are the same as those for the main body of the project.
4. 200 words long in the standard format, the abstract is essential and must be included in all reports.
5.It is recommended not to subdivide more than second level of subdivision (3.2.2)
6.The list of references should be arranged in the order of citation in text, not in alphabetical order and must be in IEEE format. Each reference should be numbered consecutively in square brackets in the order in which they appear in the text. The sentence punctuation follows the brackets.
7.The project report must be typed, in Arial, with font size 12 pt, in one-and-a-half line spacing on one side of the paper sized A4. No text in the report should be less that 8 pt in size. The page setup should be as follows: left margin 4 cm, right margin 2.5 cm, top margin 3 cm and bottom margin 2.5 cm; header 0 cm footer 1.5 cm. Pages must be numbered consecutively throughout the report, commencing with the title page, including appendices, diagrams and graphs. Page numbers should be located centrally at the bottom of the page (bottom page ?footer?). All paragraphs should be justified and separated by a single (one-and-a-half line) spacing. The first line of the paragraph should not be indented. To emphasise a word/sentence, italics should be used instead of underlying it.
8.For chapter, section and subsection headings the following font sizes are recommended: chapter −16 pt (bold, left aligned, first letter of each important word is capitalised, not underlined, not italicised), section −14 pt (not bold, left aligned, first letter of each important word is capitalised, not underlined, not italicised), subsection −14 pt (not bold, left aligned, only first letter of the first word is capitalised, not underlined, not italicised). All headings should be short and to the point. Single (one-and-a-half line) spacing should be left after and/or before a heading.
9.Lettering on tables and illustrations should be large enough to be easily legible and should be at least 8 pt in size. All tables and illustrations should be centred on the page and separated from texts above and below by at least single (one-and-a-half line) spacing. Figure captions should be placed below the figures and table titles above the tables. For these the recommended font size would be 10 pt.
[meteor_slideshow slideshow=”arp2″]
A-Research-Paper.com is committed to deliver a custom paper/essay which is 100% original and deliver it within the deadline. Place your custom order with us and experience the different; You are guaranteed; value for your money and a premium paper which meets your expectations, 24/7 customer support and communication with your writer. Order Now
Use the order calculator below and get started! Contact our live support team for any assistance or inquiry.
[order_calculator]